High Concentration PLC Control Slag Removal Machine Stainless Steel Mateiral
The high density cleaner for the heavy slag in the waste carton paper pulp
The high-concentration slag remover is an ideal device for removing high-quality metals, sand, and other heavy impurities in the pulp at a higher concentration to obtain high-quality pulp. It is also necessary for the purification of waste paper pulp. Equipment.
The high-concentration slag remover uses the different specific gravity of fiber and impurities to separate impurities. The slurry enters the slag remover at a certain pressure from the feed tee and rotates at high speed. Due to the different centrifugal force, heavy impurities are thrown to the wall of the device. Under the action of gravity, it gradually runs towards the bottom of the cone and enters the sedimentation tank. Due to the small centrifugal force, the fiber gradually moves to the low-pressure area of the center, and after the bottom reaches the vortex, it rises up and is finally discharged from the good pulp port. The cone of the high-concentration slag remover has a certain taper, and the cone is longer. The rotation radius of the slurry in the cone gradually decreases, which prevents the speed of the pulp flow from decreasing during the rotation process, and ensures that the centrifugal force is strengthened, thereby improving the paper material. Purification efficiency. The balance water pressure at the bottom is slightly greater than the slurry pressure, so that the fibers cannot enter the sedimentation tank, and only heavy impurities such as sand, metal particles, rubber blocks, and plastic sink into the tank, which reduces fiber loss.
| Model | PHDC-1 | PHDC-2 | PHDC-3 | PHDC-4 | PHDC-5 | PHDC-6 | PHDC-7 | PHDC-8 |
|
Throughout (L/MIN) |
800- 1000 |
1200- 1400 |
1600- 1800 |
1800- 2600 |
3000- 4500 |
4500- 5800 |
5800- 7500 |
8000- 12000 |
| Consistency | 5% | |||||||
| Inlet pressure | 0.2-0.4Mpa | |||||||
| Outlet pressure | 0.1-0.25Mpa | |||||||
| Flushing water pressure | Inlet pressure + 0.02Mpa | |||||||



High Concentration PLC Slag Removal Machine
,Stainless Steel Pulp Slag Removal Machine
,High Density Pulp Cleaner
-
High Strength Lined Engineering Ceramic Sandblasting Nozzles For Pulp Cleaners
7. High wear-resistant ceramics blasting nozzle of the pulp cleaners Ceramic nozzle is in the end of the cleaner ,it is the main spare part of the equipment . the slags removed from the outlet The lining ceramic layer of the wear-resistant ceramic elbow is a wear-resistant engineering ceramic, whose ... -
304 Stainless Steel Pulp Screen Plate For Waste Paper Pulp Cleaning Process Defibrator
Stainless steel screen plates / sieve plates of the waste paper pulp defibrator The sieve plate is an important filtering component on the pulper, and is generally made of stainless steel. 1. Good abrasion resistance and long service life, more than ten times that of metal screens, 3-5 times that of ... -
Inward Flow / Inflow Pressure Screen Stainless Steel For Paper Pulp Cleaning
Stainless steel inward flow / inflow pressure screen for the paper pulp cleaning The outer rotor inward flow / inflow pressure screen is an advanced pulp screening equipment, which can be used for pulp screening in the middle of pulping system and for pulp selection in front of the paper machine. ...