Français
Deutsch
Italiano
Русский
Español
Português
Nederlandse
Ελληνικά
日本語
한국
العربية
हिन्दी
Türkçe
Indonesia
Tiếng Việt
ไทย
বাংলা
فارسی
Polski
-
2400mm Frame type underfeed rewinder for printing paper The paper rolls (called base paper rolls) produced by the paper machine are sequentially rerolled. After the paper is rerolled, it is made into finished paper. The paper roll rolled by the paper roll machine is relatively soft, there may be ...
-
2. The high consistency pulp stuff slag remover for the OCC paper recycling The double-cone high-efficiency and high-concentration slag remover is composed of inlet and outlet heads, upper cones, lower cones, pressure gauges, ball valves, high-pressure water pipes, sediment tanks and other ...
-
Stainless steel screen plates / sieve plates of the waste paper pulp defibrator The sieve plate is an important filtering component on the pulper, and is generally made of stainless steel. 1. Good abrasion resistance and long service life, more than ten times that of metal screens, 3-5 times that of ...
-
4. Customized stainless steel screen sieve plate in the hole / slot vibrator 1. Good abrasion resistance and long service life, more than ten times that of metal screens, 3-5 times that of ordinary rubber sheets, and 2-3 times that of stainless steel. 2. The cost per ton of mineral consumption is ...
-
2. Stainless steel dump rejector in the paper pulp cleaning system The rejects separator is an ideal equipment for tailings treatment in waste paper pulping system. Adopting closed operation, no splash of pulp water, good treatment effect, reducing fiber loss, and low slag disposal cost. It is a ...
-
Type600 stainless steel fiber separator for the pulp cleaning The fiber separator is a screening and pulping equipment with a combination of disintegration, separation and screening functions to remove various impurities in the waste paper raw materials by utilizing the specific gravity difference ...
-
The bottom transmissison stainless steel body waste paper hydrapulper This equipment is a vertical structure, which is mainly composed of a trough, a rotor, a transmission part, a pulp tray, a bracket and other parts. The rotor device is composed of a rotor and a bearing support device. The rotor is ...
-
5. Stianless steel impeller blade for the high consistency hydrapulper The impeller blade is an important filtering component on the pulper, and is generally made of cast stainless steel. 1. Good abrasion resistance and long service life, more than ten times that of metal screens, 3-5 times that of ...
You Might Be Interested In
